VWSyncro Logo
Search | Clear search
Only one result found, previewing...

Click for larger/smaller image
Click for larger/smaller image
Item title
Easyweld rods test #1
Description
The test subject
Full description
This is a 16v breather fitting from a KR block. It normally has a steel insert cast/shrunk into the big hole. Since the g60 block has different spacing for the breather assembly I had to make my own which necessitated removing the steel insert to use as a base. I figured this would be a decent enough first test since it wasn't a load-bearing part and there was plenty of surface are to play with.


My aim is to relatively neatly fill the cut in the side made with an angle grinder to remove the steel insert.

Info
Filesize: 173 kb
Created: 24/12/2015 03:52:12
Modified: 08/10/2010 00:56:00